Resureksi » E398 http://resureksi.com Ressurrection Thu, 31 Jul 2008 23:54:29 +0000 en hourly 1 http://wordpress.org/?v=3.2 Motorola E398 USB Data Cable and Charger Modification http://resureksi.com/online-tutorials/motorola-e398-usb-data-cable-and-charger-modification/ http://resureksi.com/online-tutorials/motorola-e398-usb-data-cable-and-charger-modification/#comments Fri, 11 Jul 2008 07:59:30 +0000 asu http://resureksi.com/?p=67 Motorola is difficult mobile phone, when you are trying to replace the charger with non-original one, then the phone will tell you “Invalid Charger”. To avoid this case, this tutorial below is show you how to modification data cable which enable for both for charging or transferring data. So your Motorola data cable will more usefull not for flashing only.

Here is your data cable look alike.
Data Cable Shown

Data Cable Shown 1

1. Open it up and get all wires out
Open the cable 1

Open the cable 2

Open the cable 3

2. Remove the protection
Open the cable 4

3. Check out the pin scheme by clicking on the picture
Make pinout

Make pinout 1

4. Scratch the panel on the back and Solder 22Komh resistor end on pin 2 and the second on the scratched place (ground)
add 22K resistor

repack

now you have modded your usb cable!

(originally taken from:modmymoto)

]]> http://resureksi.com/online-tutorials/motorola-e398-usb-data-cable-and-charger-modification/feed/ 0 Motorola E398 Dead, How to Revive http://resureksi.com/mobile-phone-repair/motorola-e398-dead-how-to-revive/ http://resureksi.com/mobile-phone-repair/motorola-e398-dead-how-to-revive/#comments Sat, 05 Jul 2008 15:46:32 +0000 asu http://resureksi.com/?p=61 There is no big deal if your motorola E398 suddenly dead. I will show you step by step how to bring your motorola E398 live again.

all you need is:

1. Dead Motorola E398

2. USB data cable for motorola E398

3. Moto Repair Studio Trial Version ( i’ll tell you where to get it later)

4. Firmware motorola E398 full flash version

5. Some software for flashing (RSD, PST, Flash&Backup)

sorry, i got to go… i will continue later :D
this project was terminated, because my phone totally dead when backing up PDS

]]> http://resureksi.com/mobile-phone-repair/motorola-e398-dead-how-to-revive/feed/ 3